In-Crop XtendiMax® With VaporGrip® Technology A Restricted Use Pesticide Application Reminders

​​

POST applications to Roundup Ready 2 Xtend® soybeans can be made from emergence (cracking) up to and through R1 growth stage (one open flower at any node on the main stem). The maximum and minimum rate for a single in-crop POST application is 22 fl oz/acre. Spray weeds early when they are less than 4 inches tall. A second application of 22 fl oz/acre can be made at least 7 days after the first application and up to the end of the beginning bloom stage of soybean growth.

Table 1. Summary of Application Requirements*
In-crop applications. Cracking up to and including beginning bloom (R1) in Roundup Ready 2 Xtend® soybeans.
Apply 22 fluid ounces per acre for any single in-crop application
For best results, spray weeds that are less than 4 inches tall
Apply in a minimum of 15 gallons of spray solution per acre
Do not use ammonium sulfate or ammonium-based additives
Use only approved nozzles within specified pressure
Apply when wind speed, measured at boom height, is between 3 and 10 mph  
(DO NOT spray during an INVERSION)
DOWNWIND BUFFER
Maintain the required label buffer (Minimum 110 ft. buffer at 22 fl oz/A rate)
Do not apply by air 15 mph ground speed or less. Do not apply when wind is blowing toward adjacent susceptible crops
Do not exceed a boom height of 24 inches above the target pest or crop canopy
Ensure that entire sprayer system is properly cleaned before AND after using this product
*This summary is not a substitute for reading and following all product labeling.

XtendGet updated information at www.xtendimaxapplicationrequirements.com​